AV Surfboards

The Fir - 9’5” x 23” x 3” for

The Fir is our toes on the nose longboard. It carries a soft rail through the tail which helps lock you in and feel more control while on the nose. The outline has a wider hip behind the center point, that gives you a pivot point to turn off of and helps with stability while getting up to the nose. We lowered the rocker on this one slightly for Arye who has been surfing a lot of low rocker hull style boards that we have been making him.

Two custom longboards for Kenta! It’s always super fun building boards for someone who has a good understanding of board design and what they are looking for! Challenge accepted, and feedback so far has been great! Glassed by stoked to be building high quality boards in the PNW with Brad! 🤙

We can mix up colors and lay down rad swirls, but it’s hard to beat some good old wood grain. These two are built in EPS/Epoxy with a white oak veneer vacuum bagged to the deck.

Rounder Flounder: 6’0” and 6’6”

White Oak
Rounder Flounder
6’6” x 21 1/4” x 2 5/8”

EPS/Epoxy with Vacuum bagged white oak veneer deck.
The most sustainable surfboards are the ones made locally and made to last!

The Rounder Flounder
6’0” x 21” x 2 1/2”

EPS/Epoxy with a White Oak Veneer Deck.

The Veneer is a thin piece of wood that is vacuum bagged onto the deck of the board. It creates a very strong board while also adding some dampening to your normal EPS chatter. All while weighing about the same as an equivalent poly board!

A closer look at the Lumina that I finished up last week!

5’8” x 19” x 2 3/8” 28L

Built in EPS/Epoxy with grab rail channels on the deck.

Reverse lam acid splash. Check out the last few reels to see the build process!

The Lumina
5’8” x 19” x 2 3/8”

The Lumina is our performance groveler, it loves small to average surf up to head high + and does really well in mushy points and broken up beach breaks. Designed to make sub-par surf fun and rip-able again!

This one features EPS/Epoxy construction with grab rails and an abstract acid splash.

The Lumina
5’8” x 19” x 2 3/8”

The Lumina is our performance groveler, it loves small to average surf up to head high + and does really well in mushy points and broken up beach breaks. Designed to make sub-par surf fun and rip-able again!

This one features EPS/Epoxy construction with grab rails and an abstract acid splash.

Open House!
Saturday 09.23.2023
11AM - 2PM
10278 N. Tyler Ave. Portland, OR

2 Bed | 2 Bath | 1424 sqft
Come check out this awesome North Portland Home with an income producing lower unit.

Listed by Page Jordan

Custom Rounder Flounder

6’0”• 21”• 2 5/8”

Eps/Epoxy Acid Splash

This board is going on quite the adventure! It’s new owner is taking it on a bicycle trip down the west coast, stopping to surf along the way!