D&G Racing

ESS installed, tuning by Lund and ready for delivery. 6r80 and converter replaced on a customer’s S550, Vengeance clutch on another customer’s S550, and lastly a vengeance clutch on a customer’s terminator. Let’s get it 🇺🇸🇺🇸

Two quick jobs knocked out. Headers on a 24 GT, new radials and alignment on another one here. I will be out of town next week, but we will be open, got my guys setup with appointments while I’m out. As always, let’s get it 🇺🇸🇺🇸

Busy as usual! New vengeance clutch installed on the first customer’s car, next we have a customer’s f350 got new rotors and pads along with new front calipers,next we have a customer in for a 6r80 swap, then opg and cs on another. Let’s get it 🇺🇸🇺🇸

Just wanted to let everyone know that I will not be here all next week. The trip my pops and I planned will be then. I will not be available by phone during that time. Leave messages or voicemails as usual, and I’ll get back with anyone when I return. Thanks

Got some time and knocked out the taillight and headlight harnesses on our coupe. Plus, ran the hoses for the ice tank.

Week of the 24+ mustangs here at the shop. Long tube headers on the first GT,fore innovations fuel system on a Darkhorse we did a Whipple on awhile back, and another Darkhorse in for opg/cs in preparation for a power adder. As always, let’s get it 🇺🇸 🇺🇸

We got this first customer taken care of yesterday, dropped off for a complete service…o/f change,tire rotation,transmission service,coolant system service,tune up,rear differential service and a complete inspection. Next diagnosing an issue with the charging system on this customer’s car, traced down to an open circuit within the connector itself going into the alternator, new pigtail ordered to remedy this issue. And a set of headers along with service being done on this Darkhorse. Let’s get it 🇺🇸🇺🇸

We’ve got this F150 in the shop that we are in the process of doing a Coyote Swap On along with many many other upgrades to the whole truck! We’ve also got this customers S550 N for a replacement clutch finished and ready to go. We’ve got another S197 in here for a rear end job finished and ready to go as well. Plus, many many other projects we’ve got going on and are starting on and in the process of finishing up! When I say we stay busy, that’s no joke! It’s a blessing really! We keep growing and growing year after year. At the rate we’re going we’re gonna have to move into another building soon with more room, that’s for sure! As always, let’s get it! 🇺🇸🇺🇸