GraouLab

🆕 Sword Of The Stone

Rappel : le fablab est ouvert de 14h à 18h, ce dimanche 14 juin ( ouverture habituelle).

https://www.instagram.com/reel/DZO9tWdMKKu/?igsh=MTZ2ZjVwc2Jhdzd4eQ==

Since Toasty's head is finally finished, I wanted to show you how I made the visor. It is completely self Made. Vacuum formed and tinted. -The master is 3D printed in PETG and sanded. The file is from @snowkatsoftwear -Material for the visor: I used 2mm PETG. I also tested one with 3mm. That works great too. -I built myself a vacuum box and a frame. -Screw the PETG in the frame and put in the oven at 130°C for about 4 minutes. Use soft gloves to avoid scratches. Then quickly pull it over the master and let it cool down. -After removing the master, you can cut out the visors and sand the edges. -Left and right you have to make 2 small holes in the edge. You won't see them later due to the frame of the Fursuit Head. Then wash off all the dust. -Now put copper wire into the holes to hang the visors for tinting. -For tinting I used a self heating WECK pot. The pot has to be so big that the visor dont touch the bottom. -Heat the water to 80°C and dissolve 'iDye Poly Black'. For about 15l of water one pack. Stir the paint and clean the surface of the water with a cloth. -Let it cool to down to 60°C. Now the visor can be hung in the water. -The visor must be removed every 5 minutes. Check the result, stir the water and check the temperature. -If the temperature falls below 50°C, the water must be reheated. To do this, take the visor out of the pot! ltk -When you are satisfied with the result (for me it was about 70 minutes) , rinse the visor with cold water and let dry. Done :D The visibility with the visors is super good. I did this with the instructions from @proto_furo Feel free to look at his original instructions #fursuit #tutorial #protogen #suitmaker #furry

Graoulab ouvert ce dimanche 7 juin de 14 heures à 18h. ( ouverture habituelle.)

Graoulab ouvert de 14h à 18h ce vendredi 5 juin. (ouverture supplémentaire)

https://www.leferudessciences.eu/agenda/details-agenda?uuid=ba29f692-36dd-11f0-ad9d-8bd2ed264ddb

La fête des makers Samedi 06 et dimanche 07 juin 2026 de 14h à 18h : Réservez votre week-end pour découvrir des projets créatifs et des constructions originales.  Inventrices, artisans, artistes ou entrepre...

Graoulab ouvert de 14h à 18h ce dimanche 31 mai. (Ouverture habituelle)
L’atelier cosplay est de 14h30 à 16h.