Custom Scouts

Comin along 😃. Dash mods for Tach and Cummins Multiple function Murphy Gauge. If you want yours swapped give us a call or email [email protected]

It’s been a minute since we shared an update on the #B2WScout… but rest assured, this build is very much alive — and evolving fast thanks to the killer work from @customscouts. ⚒️🔥 Earlier this year we shipped the Scout to Canada for a full sheet-metal resurrection. JT literally split the truck in half and cut out every rusted panel. The front floors, rockers, kick panels, cab mounts, and wedges were all replaced with 100% stainless steel panels made in-house from Custom Scouts. From there, we teamed up with @ejclassicsco to overhaul the entire back half. We added OEM-quality inner & outer quarters, rear wheel wells, rear floors, and a brand-new trans tunnel. Aside from the doors and tailgate, the Scout is essentially new from the firewall back. The fit and finish of these panels is unreal — exactly what the Scout community needs to keep these rigs on the road for decades to come. Next up: Custom Scouts reshaped the rear quarters to clear the 37” @nittotire Recon Grapplers, hand-working the metal with a hammer & dolly to keep the body lines crisp. The front fenders were cut and widened as well, with donor panels from @ihpartsamerica so we could maintain factory lines while maximizing up-travel and keeping the stance low and functional. Every inch of clearance matters when you’re building a rig to perform, not just look good. The Scout is now back with @3d_offroad to finalize the chassis and get it running & driving. After that, it heads to @karlecoachwork for final bodywork and paint — then interior — and we’ll finally get to see this vision come to life. This project is a massive undertaking, but watching each chapter unfold has been a blast. The best is yet to come! 🙌🏻 #Built2Wander #HellScout #CustomScouts #3DOffRoad #EJClassics #IHPartsAmerica #NittoTire #ScoutMotors #B2WPitCrew #InternationalScout #AMW4x4#

Just added this little gusset and cover to keep all the leaves and water out of this area behind the ScoutII front fender. This will work together with another modification we’re doing on this customers build, that will prevent the front fenders from ever getting rusty again. 😎🙌🏼

Look at this beauty that just showed up for our next restomod build. 1975 ScoutII. Brand new AtlasII Transfer Case.

If you’re looking to get your scout or other IH restored and you want custom parts like this reach out to us at [email protected]

What do you think of our new rear show bumper on our customers build? Also showing off our very popular rear bumper splash shield, mounted to the rear crossmember behind this bumper, for a clean and sleek look from the rear. Contact us if you want a budget friendly front or rear bumper for your Scout. [email protected] www.customscouts.com

Piece by piece it’s moving towards paint and body. Makin dreams come true. 😁