DarkSide Chops/Rods

63 pan Engine mounted in paughco frame front motor ears shimmed and top mount shimmed. Addressed frame to accept trans plate installed baker 6 speed along with tech products belt drive and starter setup. Now onto trimming down this oil tank to fit over top of massive trans mission as well as clearance for Clarence clutch arm.

In search of a a OEM original rear 53 74inch Pan cylinder. Have a good std bore front in search or a rear or something 10 or 20 over that's not wiped out. Have a matching 53 set that is up for barter that are 60 over that just need a good hone and this one that is a rear that the wrist pin clip jump ship. Private message me with any leads or direction thanks. NOT LOOKING FOR AFTERMARKET.

TBT the day the blue print in my head started taking shape

Panheads FOREVERRRR

Some work flow in the new compound this cone shovel gives off that David Mann vibe. Had open 1 1/2 belt putting chrome sheet metal Pan nock off on to cover it up.

Some 930 amal premiers getting a freshening up today's pump fuel sucks ass

FOR SALE $600 champion commercial air compressor. 120 gallon 175 max psi has a 10 hp baldour motor 3 phase 240 volt. Has a 110 volt auto air water seperator drain and a cooling coil. Sold as is and buyer responsible for pick up located south jersey area DM me for any other details.

Lathe sold so of course that money goes rite back into shop. So upgraded the shop air compressor to a 80 gallon job. Now to plumb the whole shop.

My buddy Matt snagged some killer shots at the Cheap thrills show in Asbury park of my drag bike. These pics shot rite on the street out front of the convention center.

Small task for today measure and cut wheel spacers to fit this war gasser wheel on a phares cycle parts narrow springer

4130 chromoly axle made for a Fox Factory racing front end