Millers automotive

We're currently halfway through a busy day at Miller's Automotive. Klay completed a project from yesterday on a 2000 Chevy Impala and began replacing the valve cover and front brakes on a 2016 Buick Encore. Ej is working on a 2014 Lincoln Navigator's exhaust system replacement. Darnell finished a transmission swap on a 2002 Honda Civic and started an engine swap in a 2009 Jeep Wrangler. Eddie is making progress on our tow board today. Happy Hump Day everyone.

Dropping the motor and transmission is the preferred method today, making repairs significantly more efficient and less labor-intensive.

The morning begins with a strong start. Klay is examining an oil leak issue on a Isuzu Rodeo. Ej is performing repairs on lifters for a 2015 Dodge Charger. Darnell is replacing the engine in a 2000 Chevy Astro Van.

We have a full schedule today. To start the morning off Eddie and Klay are working on setting a rear differential up to be reinstalled in a 2011 Ford F350. Ej completed a thermostat and coolant temp sensor replacement on a 2010 Cadillac Escalade and is now helping Darnell move an engine so that parts can be swapped over on a 1996 Ford F150. It seems like it’s going to be a hot summer this year we hope everyone is staying cool and hydrated!

It’s an all hands on deck kind of day. Ej is working on replacing the clutch in a 1998 Chevy S10. Klay replaced the front brake calipers on a 2002 Chevy Silverado, removed the AC Compressor on a 2017 Dodge Ram 1500 and is now working on doing a list of repairs on a 2017 Chevy Express Van. Eddie replaced the fan and connector on a 2012 Chevy Sonic. Darnell finished the flywheel replacement on a 2011 Dodge Charger and is now working on a list of repairs on the Adult Corrections vehicles. We hope everyone is having a good hump day!

It’s been a busy day here at Miller’s Automotive. Klay just finished an oil change on a 2024 Kia Soul after Eddie inspected the horn. Klay is now working on removing the timing belt on a 2007 Chrysler PT Cruiser. EJ was completing a diagnosis on a 2018 Hyundai Elantra and is now working on replacing the fuel injector on a 2014 Jeep Grand Cherokee. Darnell did a visual inspection on a 2006 Chevy Equinox and is now working on replacing the transmission in a 2018 Chevy Silverado. We want to thank our technicians for their continued hard work in providing quality service to our customers. We as always want to thank our customers for trusting us with their vehicle repairs!

A few new projects are being started on this morning. Klay is working on replacing the evaporator and expansion valve on a 2006 Honda Accord. Ej is working on swapping an engine in a 2009 Pontiac G3. Eddie is working on finalizing repairs on a 2016 Ford Transit and Darnell is working on replacing a starter on a 2012 Dodge Grand Caravan. It’s a busy hump day here at Miller’s Automotive. We’re hoping for decent weather in case any more repairs need to be completed outside.

We were closed yesterday in observance of Memorial Day but we are back open and in full swing this morning. Klay is starting the morning off by doing a list of repairs to a 2006 Honda Crv including replacing the a/c condenser fan. Ej is working on finishing swapping parts to the new motor on a 2013 Nissan Pathfinder. We have a new member of our team Darnell he started with us last week and he is working on replacing the rear main and oil pan gasket on a 2017 Nissan Murano he had it tore apart Friday and is working on swapping the bad parts now before working on putting it back together. We hope everyone had a safe Memorial Day!

We are nearing the end of the week with a considerable workload to address today and tomorrow. Currently, Klay is installing an air conditioning compressor on a 2013 Hyundai Elantra, having faced challenges in finding a reliable used part for this particular model. Following the completion of this task, he will move on to replace the water pump and timing cover of a 1997 Mercury Mountaineer. In other areas, Eddie is busy replacing the rear driveshaft of a 2017 Jeep Wrangler, and Ej is working on identifying the cause of a misfire in a 2016 Ford Explorer, prior to commencing work on replacing a torque converter in a 2019 GMC Terrain. With our schedule fully booked and additional appointments lined up, we are grateful for the trust our customers have placed in us and assure them of our best efforts despite the limited techs we have. We appreciate everyone's patience and wish a great Thursday.

Our technicians are currently occupied with various tasks. EJ is performing a front end kit swap on a 2005 Dodge Ram 1500. Klay is replacing both front CV axles, cleaning the tracks on the sliding doors, and conducting a tune-up on a 2006 Honda Odyssey. We hope you are all having a productive Wednesday.