ReNewSnow
Share
Disrupting the world of Snowmaking with solutions that enable ski resorts to virtually eliminate CO2 emissions and reduce energy costs by 30%
11/19/2022
The stream is starting to get covered in snow, but plenty of water is still running below!
11/15/2022
November 13, 2022
Water flows down the side of the Green Weaver ski trail. To test the accuracy of our sensors, we measured the flow rate using a bin.
4.5 seconds to fill an 18-gallon bin = 240 GPM
The SnowPod is secured and installed! Lots of troubleshooting still to be done, but all of the pieces are in place.
After a snowmelt event, water will rush down the mountain for several days. Even after the temperatures have dropped again (snowmaking conditions), we estimate that this stream's flow could reach as high as 500 GPM.* Our SnowPod system will capture this water and redirect it to nearby snow guns. A method that will dramatically reduce the cost of making man-made snow since minimal pumping is required. Saddleback Mountain currently pumps water for its snow guns from Saddleback Lake, nearly 2.8 miles away.
*Based on data extrapolated from the Hubbard Brook Experimental Forest.
11/12/2022
It’s all coming together. The SnowPod has arrived at Saddleback Mountain. It will soon be secured to the stream bed and connected to the weir. More to come!
11/10/2022
Installation of our weir occurred this morning. With the help of an excavator, we installed two large plates in the middle of the stream that runs along the Green Weaver ski trail. Snow covers the stream during the winter, but it flows continuously.
After a snowmelt event, our SnowPod prototype will divert the flowing water directly to nearby snow guns. This method dramatically cuts the cost of recoating the slopes since the ski resort isn't required to pump the water back up the mountain.
Clean - Energy Efficient - Snowmaking
#
11/07/2022
ReNewSnow's Science Hut! Located adjacent to the Green Weaver ski trail on Saddleback Mountain, the science hut will serve as the company's base of operations mid-mountain. The hut is primarily needed to house our pump, but it will also host additional equipment.
11/07/2022
ReNewSnow visited the HKD Snowmaker’s factory in Quebec last month. In the photo is the airless, low-energy HKD Volt tower snow gun. The Volt is the model we’ll use on the slopes of Saddleback Mountain this winter to test our SnowPod.
Click here to claim your Sponsored Listing.
Category
Contact the business
Website
Address
Portland, ME