No Limit Performance

Toyota in for an engine replacement
Car was dropped off with no drivetrain installed, came with all the parts just needed to be assembled

Recently got a 460 for Kodak, one of our shop cars. Took it to our machinist and had it overhauled and ready for us to assemble our 501. Using for our fasteners, will share more of our combo after assembly. The goal with this stock block is to find our own limits with a BBF. Still looking at our options for Heads/Intake but not too worried until rotating assembly is complete. Using bearings, brass freeze plugs, and

Can you guess how much nitrous will be ran through this block!? Will be getting on board with to feed this power plant.
#460

Johan brought in his beautiful S197 for an engine replacement! 🐎
Customer sourced the donor engine and we picked it up for him, performed the R&R, as well as swapped VCT solenoids for the correct style plug in. After a few drive cycles, we cleaned it up and sent it off back to its home!

(623) 305 5537
Mobile service and roadside assistance available as well!

Keven messaged us concerned about a unusual squeal from the front of his 2005 z71 so we had him bring it in for a diagnostic and after looking under the truck we noticed that the lower control arm’s ball joints have gone out. After replacing the lower control arms we have this super clean truck back on the road.

Ali brought us his new 10r80 mustang straight from the dealership to install this long tube headers and x pipe. This utilizes the stock active exhaust, meaning we custom fitted the mufflers to this new exhaust system. We are hoping to have this back in a few days for a procharger install. Message us to get scheduled in we are here to help!

Ali brought in his 2020 SS 1le for a complete fluid change on the car. We started off with an engine oil change using oil and filter. After that we did transmission and diff fluid flush using products. Message us or walk ins are available for you’re next appointment!

4501 s 7th Ave 85041

Our friend Deric brought in his 1990 foxbody due to it having a hot start issue. After further inspection we found out his tfi module was failing causing it to only crank but not start once the car is at operating temp. Of course we took care of him and also suggested a tuneup since these old pushrod Ford engines are constantly needing freshen up. Message us for you’re next visit!

Goodmorning Instagram, we are letting everyone know that we are in a new location and now taking in more clients as of now! 4501 s 7th Ave 85041 Phx az

Reach out to us to set up an appointment or walk in is available any time between 9am-9pm Monday through Friday! Thank you everybody for you’re support 🙏