"Daft Innovations"

Bro went full EV, couldn’t handle the silence… and came back to boost therapy 😈

Sold his C7 Z06 ➝ bought a Tesla Plaid ➝ missed the LT4 life so bad he bought another C7Z.
Car runs like an absolute champ now 🔥

Sometimes electrons just can’t replace explosions 💥

V8Therapy RegretNothing

6.0 z32 Nissan 5 speed summit stage 2 cam, 1983 Volvo 240 wagon. Holley style exhaust cast manifolds. There is def a restriction it just falls off on top but def made some gains. Fixed idle issues.

1968 Camaro Z28 | Weaver Racing Chassis | LS3 + T56

Stock LS3 setup, but the car came in with a few issues holding it back.
– Cheap Chinese MAF sensor
– Incorrect MAF pinout
– Cooling fans not turning on (possible bad relay)

We replaced the MAF with a genuine Hitachi (Japan) unit and corrected the wiring. Instantly, the car ran exactly how it should. For now, we temporarily wired the fans so the customer could safely drive it home.

Shoutout to for handling a full nut & bolt check, brakes, and additional safety items.

The wild part?
The customer hasn’t driven this car in 13 years.
After the fixes, he drove it from Modesto to Alameda with zero issues.

That’s what we love to see. 💪🔥

t56 restoredconfidence

All stock lt5 with long tubes and 8 speed. Low side fuel running out on pump 91. Will be back with twin pumps and flex fuel 🔥🔥

My 1993 Chevrolet Obs crew cab I purchased to replace my 2009 Duramax. It’s not the cleanest example and was slightly impatient looking for one due the fact most are an arm and a leg to purchase. It came with a 454 with an old whipple smog legal supercharger, 4l80 with gear vendor and a 5th wheel hitch. Truck was a straight up stump puller.

Let’s just say this truck ended up leaking for everything. Engine oil, coolant lines, oil cooler lines, transmission , gear vendor , hydro boost leaked as well. Front brakes were on borrowed time. After getting sick and tired of not wanting to park this thing in my own driveway I decided to sell the old engine and swap in a new power plant.

2018 zl1 lt4 10speed 10l90 transmission.
1 7/8 long tubes
Dual fuel pumps and ptfe lines 8an feed 6an return
Flex sensor
Dual 3 to single 5 inch stainless steel tig weld exhaust
Cold case radiator and fan setup
Holley accessory drive setup
HPI wiring harness
Zr1 heat exchanger v2 Ctsv intercooler pump
Custom built supercharger coolant reservoir
Used zr1 oil pan with billet oil cooler adapter
Engine oil and trans cooler mounted behind front bumper
Factory ac working with custom lines
Motion raceworks catch can
Dakota digital HDX dash with canbus module
Dakota digital fan controller and fuel pressure addon
Weight 5950 with full tank of gas 34gal
10mpg in town 16 hwy
Factory 4.11 gears eventually 3.42

93 Obs project truck. 6.0 t56. Dyno graph wavy because no weight in back and has struggling to get traction lol.

2005 Ctsv m6 lq9 with ls3 top end btr stage 3 cam. Would have made more power but dipstick tube was missing and couldn’t rev very high without oil spitting on header 😅😬

2011 c6 automatic cam only. Btr stage 2 v2. All stock otherwise.

Nice little Obs rebuilt and I dialed in!

Nice little Obs rebuilt and I dialed in!