Eckard Engineering

A little panel fitment adjustment… Super happy with my results… A common problem for the C5 Corvette is fender sag.. The bottom bolt will break loose (fiberglass cracks) the panel starts to sag and hang’s low and gets a wide gap at the bottom… I adjusted the 6 mounting points (3 up top, one hidden and one at the bottom)… I think this is about as good as it’s going to get on a 24-year-old old car….

I finally got around to installing my OvertakeAuto carbon fiber / resized D bottom steering wheel upgrade. What a great fit and finish… quality product.. and with the right wheel puller.. went smoothly..

Just a little font end enhancement with a Sarona Designs fromt lip…

C5 Corvette Check Engine Light - DTC (How to Easily Access Your Codes & Troubleshooting Tips) What do you do when your check engine light (DTC) comes on? Don't panic, your C5 Corvette has a powerful build in Driver Information Center (DIC) that gives...

BTR JAM CAM...

 On Father's Day I decided to take my father (79 Years old) out for a ride in the supercharged Corvette. He hadn't been in the car since I made all the modifications and we certainly tested the 738RWHP....put a huge smile on the old mans face... It was a typical summer day in Florida, hot as hell, so we decided to stop over at a local drive-through. I put the car in park and shut it off to let it cool down a bit. That proved to be the beginning of the end of Father's Day and our Corvette excursion. I had a failed shift cable and a tow truck was now on the way.

I searched for posts to see what videos were out there but nothing good... It's not really a big now that I've done it... but there was but a few and not detailed...Below are a few videos of what it took to replace shifter cable and I also replaced the fuel filter while there. It's about 1 1/2 hour job with a lift.. below are some pictures and videos, along with some tricks to use along the way to make it happen faster (uses a drill for all those torque to cover bolts) enjoy and if it ever happens to you hopefully these videos will help you find your way back to a Corvette day...  — in Merritt Island, Florida.

finally getting back to finishing up the C5 ZR wide body prototype fenders... really happy with how they are progressing...

Starting a full restoration of this 1969 Oldsmobile 442 Convertible. It will need a lot of steel, but should be a near perfect example when finished.

Gearing up for our next project, a 1969 Olds 442 convertible that will be a total restoration. So off to the storage facility the W-30 heads for safe keeping... The new 24ft enclosed car hauler really does the trick..