Dark_Knight_WJ

Getting the hubs installed pair with lockouts. Also got the high steer arms installed and ball joints in.






4wd

So stoked when parts start coming in. My from came in today can wait to get these installed and the jeep sitting on its own weight.




4wd

Are you watching KOH2026? This is my

Got the truss welded up and one of the high steer mounts. Waiting for the reamer to come in to drill out the factory mounting location on knuckle. Now I need to finish up the knuckles and get front gears and locker ordered.

4wd

Getting the next step of the swap started. I have the factor brackets cut off and tubes cleaned. Getting the truss mocked into place. 1 step closer. I am using the .4wd TJ truss on the WJ due to the fact that the truss sits 2” higher like the WJ factory mounts do. Everyone else’s are lo-pro sonI would loose that height. I am still planning on running the 5.5” springs for a TJ like rear to keep the level.

If you are out .hero make sure you stop and grab some jerky from there habanero is spot on great flavor with a little heat.

Had a really fun time today .hero did the Definitely different wheeling a truck with than it is wheeling a .

Made out to .hero got all set up at can’t wait for the week of fun.

On my way to .hero stopped in Vegas for the night. Before I leave to had to stop by for some food and a couple beers. Come say hi at trial hero I will be hanging out with

Finally got the rear suspension to a point where it can sit at full stuff. Now to figure out what coilovers to run in the rear and replace the rear bumper. Then we should be off to the front.

Had a little time this morning to get some installed to hold the axle shafts in.