Raven's View Forge

I recently made an Oath ring for a friends wedding. It was a tough one. Started with 24 inches of 5/8 square and drew out 4 inches of one end until it was 32 inches. I then split the other end of the bar to make the top and bottom lip of the dragons mouth. I then did the twist. After that was bending into the ring, which I would suggest that if you plan to make one you make sure to have a big enough Forge for the material you are using... or you will have to fiddle with it or use a seperate heat source. I enjoyed the process a great deal, though I think I will make more with smaller stick in the future.

I just finished an order for a customer which was a towel bar, a TP holder, and three drawer/cabinet pulls. I had a great time making them!