Rotors By Scott

Here is a Hygain 300 antenna rotator for Jim out of OK

Another Hygain 300 antenna rotator This Hygain 300 antenna rotator is for Jim out of OK

Here is a Yaesu G-2800 controller with a knocked loose transformer. I don't know how it happened? If it happened when it was shipped to me. But here are some pictures of the base of the transformer when i removed it and the fix

Here is another video on the Wilson WR-1000 for Chris out of TX

Another Wilson WR-1000 rotator Here is another Wilson WR-1000 rotator for Chris out of TX

Been adding the 6 pin molex to the Yaesu SDX controllers. Dual output

Here is a Video on how to make a Yaesu G-1000SDX rotator controller work on a DXA rotator and cable set up.

How to make a Yaesu SDX Rotator controller work with a DXA rotator and control cable Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on YouTube.

Another video on a Wilson WR-1000 rotator controller.
This one has a relay installed in it to prevent it from turning before the wedge brake is released.
Ask me how i know its bad to try and turn it before the wedge brake is released.
It also has a 12vdc led lit bar installed and i used a 15vdc wall wirt to power the led lite bar.

New lite setup for the Wilson WR-1000 controller and added a relay to prevent rotation Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on YouTube.

Here is another Wilson WR-1000 Rotator, Testing and adjusting the pot calibration.

Another Wilson WR-1000 antenna rotator Testing and celebrating the pot

Here ia a 3D printed battery cover for a Turner Expander 500 printed by Dennis at Back Porch Customs in FL

Battery cover for the Turner Expander 500.Made by Dennis at Back Porch Customs Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on YouTube.

Want to upgrade your hygain Ham M, 2,3 to a steel ring gear or replace your broken steel ring gear in a ham 4 or tail twister?
Contact me for this special deal that includes tear down, clean and replace the ring gear, l**e, calibrate the potentiometer and test. 350$

Nice J*p. quality. Hand tight screws on this motor plate. M3X.50X8