Automotive Machine

Hone job on a Brodix BBC.
Going to seal up real nice 👌

Pair of stroker v6 Buick short blocks for some nice GN’s.

Beautiful cast iron weld repair on this Dart LSNext block. Engine had a rod failure and punched a hole through the oil pan skirt. Since all the trauma was just below the pan rail, it was definitely worth trying to save and keep this block out of the scrap pile. Kevin Chapaton is a magician with the welder!

LS with a 2650 Harrop blower

“No holes” balance job on a nice Winberg BBF crankshaft. This crank was 200 grams heavy on each end, which required 1/4” of counterweight to be turned down 😩. It was a tricky one to get right when the imbalance started moving off the counterweights when it got closer. A couple strategically placed Mallory slugs got it tuned in nicely.

💪 L8T short block ! 💪

Going to be a really stout piece. We put ARP main studs in the bottom end, balanced the factory crankshaft(which is a beast of a crank). Used the best piston and rod combo in 🇺🇸, honed the block .005 over with torque plates, fresh surface on the decks, clevite H series bearings. Going to be a screamer for sure!

Another one heading out the door!

416 LSA we just finished up.

Clean means clean 🧼

Winning pulling truck tonight at the Butler Farm Show. Congrats Richard

Donovan big block Chevy that we machined for 55 mm roller cam bearings and .937 keyway lifters.