Bowen Built LLC

Oh man this is shaping up to be SO SICK!! Tyler's Frankenstein Terminator is running smooth🤘 she came in for a full alignment so that he can start getting some break-in miles on her. A lot went into building this engine and can't say thanks enough for the help from

Total Engine - Bloomington, MN


The way is pulling this build together is absolutely stunning! I am honored to be a part of this full build!

This original 1966 Mustang Convertible came in for a quick axle seal replacement and differential service. Had the original seal and what looked like the original fluid🤣

This 08 GT500 was in earlier this summer after bouncing around a few shops that couldn't figure out their issues. Being a Senior Master mechanic at Apple Valley Ford for 17 years has its advantages. Fixed the syphon system on the fuel sending unit and now they aren't running out of gas at half full and rerouting an EVAP line away from hot exhaust cures that pesky check engine light. A few other maintenance items taken care of and now she is ready to be enjoyed for the year.

This Wrangler came in for a full 3.5" JKS suspension lift. Some before and after shots. Impressed with this kit!

This gorgeous Pantera never gets old😍 I mean just look at it!

This absolutely MINT 2011 GT500 was in for the tried and true bolt ones. Metco 2.5" pulley with Idler and a JLT intake feeding the Ford Racing throttle body! All of this tuned to perfection by Casey with DCtunes!

Trying to keep up with the ever growing list here at Bowenbuilt. Here is a beautiful grabber blue GT500 in for maintenance this summer.

Pair of 08 GT500's 😍 love it when I have two of the same cars with inverse paint jobs!

This 1970 Mustang had to go under the knife and have the strut towers replaced and a number of repairs. Then came in to have the suspension setup correct and dial in the alignment. Quite a bit of adjustment needed as seen from the before side shot! Everything came out really well and the car tracks really nice and steers smooth!

This GT500 came in for a few rear suspension additions. stop the hop kit with spherical LCA bushings. Good way to keep that rear suspension lined up when getting deep into the throttle! Dialed in the alignment and sent her home. Sounds like she may be back later this year for a header install👍