Standard Electric Works

Merry Christmas from all of us at Standard Electric Works. You should check out our Christmas display at our shop!

Shoutout to .e._sparky for calling us to get his customers' parts washer repaired. We did diagnostics on it and found a bad float valve plus some wiring issues. Got it up and running for the customer.

Everyone decided to bring generators in for repair last week. 4 in front of me and 5 more in the building awaiting diagnostics

Our customer bought this super nice lathe but didn't know that he didn't have 3 phase electricity. So, we installed a phase-a-matic phase converter to get him up and running.

These packouts are not floating, the tower is just taller than the man that's pulling them. Hahaa

We're quoting a job to replace this panel, and I just had to post this. Like, who did this...why did you do this, and where can I find more of your work to replace stuff like this.

Replaced this rusted out box and installed new starters, rewired and cleaned it up second photo is the new one. Also marked out which starter controls which circuit.

Why is it a lot of electricians don't map out breaker panels or mark which starter controls which circuit?

Panel cleanup and rewiring. 1st is before and 2nd is after. Our customer couldn't find which circuit was on which breaker. So we cleaned it up, marked wiring and wrote up the breaker map.

Service call tomorrow for Chris and Taylor to remove 3 old telephone poles, install 3 new 35’ poles and run new overhead wiring.

A big thank you to last week for the quick and knowledgeable service on our customers trailer last week.