C.W Autobody

10a nose cone top section looking as good as new now.

inner A-pillar panel fabricated to fit like factory, putting the power hammer to good use, I will be making these to order if your in need for your rx3 restoration.

Yea na good times fixing this, roll cage removed with gas axe? Making silk purses out of sow ears tools banging on the metal

familia floor braces removed and repaired, sandblasted and painted inside and L/H re-fit. tools

First set of rx3 panels made to order that will be heading to Oz along with a couple of other panels I’ve been asked to reproduce. Hare & Forbes Machineryhouse tools getting the job done

inner cowl end panels reproduced to fit like factory, I will making these to order if anyone is needing these for there rx3 restoration, very common rust area. Fit both sedan and coupe. Hare & Forbes Machineryhouse Machineryhouse New Zealand power hammer putting in the 5mm deep bead in with ease.

Something different to the usual panel fabrication. I was asked to fit factory flip up rear seat and belts to a Hiace van that didn’t come factory with mounting points. Everything thing fabricated and fitted in accordance with LVV certifier and signed off with no issues.

Polaris side by side fuel tank patch panel fabricated for one of the locals.

Another panel hammered up on the

doors repaired, blasted insides and epoxied. These door bottoms are shaped like bananas to match the sills. Everything looking factory and fitting the skins nicely.