Automechatronics

🌼 A new month is here!
We appreciate you more than words can say. May this month bring you fresh wins, good health, and happiness. Thank you for choosing us always! Automechatronics cares!!

Types of sensors

To jump-start a car safely and effectively:

Preparation
1. Find a donor vehicle: A vehicle with a working battery and the same voltage system (12V).
2. Locate batteries: Identify the batteries in both vehicles and their terminals (+ and -).
3. Turn off both engines: Ensure both vehicles are in park (automatic) or neutral (manual).

Connecting Cables
1. Attach one end of the positive (red) jumper cable: To the positive terminal of the dead battery.
2. Attach the other end of the positive (red) jumper cable: To the positive terminal of the donor vehicle's battery.
3. Attach one end of the negative (black) jumper cable: To the negative terminal of the donor vehicle's battery.
4. Attach the other end of the negative (black) jumper cable*: To a metal surface on the dead vehicle's engine or frame, away from the dead battery.

Starting the Vehicle
1. Start the donor vehicle's engine: Let it run for a few minutes.
2. Try to start the dead vehicle: If it doesn't start right away, let the working vehicle's engine run for a few more minutes and try again.

Removing Cables
1. Disconnect the cables in reverse order: Remove the negative (black) cables first, then the positive (red) cables.

Safety Precautions
1. Wear protective gear: Gloves and safety glasses.
2. Ensure proper cable connection’s: Avoid short circuits.