Rising Embedded MX

New post, the interview questions to be a embedded software developer

Interview questions for Embedded Software Developer positions - Rising Embedded Mx The answers to these questions may not be the most complete. From personal experience, I know it’s better to research and understand this rather than memoriz...

Tenemos nuevo Articulo, Las respuestas a entrevistas de trabajo para desarrollador de sistemas embebidos

Preguntas de entrevistas a puestos de sistemas embebidos - Rising Embedded Mx Las respuestas a estas preguntas tal vez no sea la mas completa, por experiencia propia se que esto es mejor investigarlo y comprenderlo que memorizarlo y no...

New post in my page.
OpenBLT running in a Bluepill plus board.

https://razielgdn.github.io/risingembeddedmx/projects/en/1-openblt/openblt-bluepill

Projects incoming!

Se vienen proyectos muy pronto.

Running OpenBLT in a STM32F103C8TX Bluepill Plus device - Rising Embedded Mx IntroductionThis project enables the use of the OpenBLT bootloader on Bluepill Plus and Blackpill development boards, providing a lightweight and flexible so...

Hello, I did an article to explain how to build and flash AVR Microcontroller projects in Linux using Visual Studio Code.

Build and Flash AVR projects in Linux - Rising Embedded Mx The purpose of this article is to guide you through preparing a Linux system to build and flash ATMEGA AVR microcontrollers. Using Ubuntu 22.04 and Fedora 39...

If you have a Zonestar Z8P 3D printer and you will print with KingRoon PETG
Here are the parameters to improve your cura setup.

GitHub - razielgdn/Zonestar3DNotesAndTricks: here I will publish what can solve or improve with my 3D printer Zonestar Z8PM4-MK2 here I will publish what can solve or improve with my 3D printer Zonestar Z8PM4-MK2 - razielgdn/Zonestar3DNotesAndTricks

Do you have a Zonestar 3D printer? You might encounter issues running Cura with its configurations. Fortunately, there is a solution. I use Ubuntu, but this should also work on Windows.

Running Cura on Ubuntu - Rising Embedded Mx IntroductionWhen I checked the documentation from Zonestar for slicing objects to print, I noticed that Prusa Slicer and Ultimaker Cura 5.7.1 are available f...

Do you know about Openblt.
It is a tool that can be used to flash a lot of microcontrollers from the same host.
I did a test and example of these, You can see it in my page:

First steps with OpenBLT - Rising Embedded Mx IntroductionOpenBLT is an open-source project. It can be used with multiple microcontrollers and protocols. This project can be ported to 8-bit, 16-bit, and ...

Welcome!
----------------
Bienvenidos