RTFM

Non Linear Circuit
Encephalo Adjuster
24 stages analogie phaser eurorack diy module from Australia, using LDRs

Video demo by the designer
Link at first comment

RTFM , Nonlinearcircuits, Andrew Nonlinearcircuits , ModularGrid

https://www.youtube.com/watch?v=DOTCXHZYkPM

Sebsongs Modular POLYSEQ | Flexible Polyphonic Step Sequencer | Walkthrough and Examples This video gives you a walkthrough and some patch examples of the Sebsongs Modular Polyseq step sequencer.Short module description:Designed with performance ...

un nuovo gioco dal nostro beloved Modulargrid
(y) evvài con i feedba # # # (y)

CV / MIDI / MIDI over USB / i2C

complete 240
minimal (without k***s) 230
barebones 190
+ shipment 15 euro in EU (UPS), 7 euro to Italy
_____
usb powered, gives at the same time:
- 16x 0-5V CV
- MIDI (trs A/B)
- MIDI over USB
- i2C controller (Monome Teletype 3.0 ready, compatible with Ansible, TXo, up to 4; ER-301)

- midi is configurable; trs midi data can be configured to be different to midi over usb data
- Teensy based, easy to flash, upgrade
- Arduino language let easily configure, alter, write firmware, open source documentation
_____
official info and user guide:
- https://16n-faderbank.github.io/
- https://github.com/16n-faderbank/16n/blob/master/README.md
_____
warning:
not to damage the 16n unit:
- do not connect 16n CV OUTPUTS to modular OUTPUTS
- do not connect AUDIO or MIDI cables to i2C input

LZX - CADET SERIES eurorack/video modules
I SYNC GENERATOR 160
II RGB ENCODER 160
III VIDEO IN 133
IX VCO 133
_______
In general sense, I focused to single modules that give the chance of using audio, eurorack modules you already have, to generate and manipulate video signals.
Cadet series menages composite video signal as input, sync, output. as explained in links below, video signal works mostly on 0-1V signals, so hotter signals need to be attenuated and pushed to unipolar (if precise control if needed).

II RGB ENCODER gives you the COMPOSITE VIDEO OUT to go to a composite video in on a screen, video projector, video mixer and so on. this is the suitable VIDEO OUT for the Eurorack to Composite Video work
it NEEDS CADET I SYNC GEN

I SYNC GENERATOR gives the SYNC signal NEEDED to have a working video system. It uses an internal bus on its own distribution cable on the rear. Module (so the whole system) can also SYNC to an external video via RCA VIDEO IN

III COMPOSITE EXTERNAL VIDEO INPUT. accepting composite video from external gear, it gives an eurorack compatible signal
suitable to be used, for example, at the place of a lfo/vco signal in R, G or B input. it gives a monochromatic image on the chosed color level. it can be used directly, or mangled by eurorack modules, an so on.
composite video out (buffered) can be used with the sync in of CADET I to sync the system to the external video signal or going to ext. video mixer, display etc

module has brightness and contrast pots acting on LUMA eurorack output (used
buffered composite video output doubles the input, to feed fourther gears, as CADET I to be synced to the external comp video signal, a (comp) video mixer and so on

IX VCO. designed to be used on video path, so voltage output and horizontal / vertical and sync capability give easy signal generation
_______
details:
CADET I
Generates the master timing signals required for modular video synthesizer in both NTSC and PAL formats.
1xRCA composite VIDEO IN to be synced to external video signals (CADET III or ext dvd or camera etc.)
1xRCA composite VIDEO OUT (same as input, buffered)
3x eurorack signal out: 3 different sync signals, useful to sync other modules to have stable visualization, if needed, or as reference for manipulation (multiplication, division, delay...)
as in user manual cadet serie uses cv/gate to carry horizontal and vertical sync pulses

CADET II
RGB ENCODER
It gives the COMPOSITE VIDEO RCA OUT (2x)
The output composite video signal is generated from the 3 signal at RED, GREEN, BLUE inputs, accepting eurorack modules sub-audio to audio rate, but responding on 0-1V. so signals need to be scaled to act as expected (usually modular levels are +-5V in LFOS/VCOS)
CADET II NEEDS the sync signal from CADET I module, from the internal 14 pin sync bus
NB: It does not work without a suitable sync signal in sync bus

CADET III
VIDEO INPUT input amplifier, it is best used for monochromatic input cameras or devices with Genlock capability.
1xRCA composite external VIDEO IN (camera, dvd, any composite video gear)
1xRCA composite video out (same as input signal, buffered, to be connected to CADET I RCA VIDEO IN so the system can be synced to external signal, for example. Or going to external videomixer, display etc.)
LUMA OUT eurorack output, result of the 2 pots manual settings Contrast and Dispaly. 1 signal, suitable to be used, for example to R, G, B input channel giving a monochromatic version of video on input. thins output can be addressed to eurorack modules to be processed before going the the RGB encoder CADET II

CADET IX
VCO Cadet IX Voltage Controlled Oscillator is a wideband triangle core VCO designed for video synthesis.
1x eurorack signal out
1x CV in with bipolar attenuator
SYNC switch. can be synced to have stable visualization, if needed, or not synced, to be free run.
HORIZONTAL/ VERTICAL switch. can act as horizontal or vertical video signal generator (difficult to obtain using audio vcos)
_______
links and docs
- CADET I user manual and general info about cadet series modulehttps://github.com/lzxindustries/documentation/raw/master/Cadet%20I%20Sync%20Generator/Cadet%20I%20Sync%20Generator%20Schematics.pdf

- LZX youtube channel https://www.youtube.com/user/lzxindustries

- more info about SYNC GEN suitable to better use the CADET I module https://www.modulargrid.net/e/lzx-industries-video-sync-generator

- more info about RGB ENCODING suitable to better use the CADET II module https://www.modulargrid.net/e/lzx-industries-color-video-encoder

- visual cortex user manual to extrapolate general info about video sinthesys and eurorack hybridationhttps://github.com/lzxindustries/documentation/raw/master/Visual%20Cortex/Visual%20Cortex%20Technical%20Manual.pdf

- lzx official website https://lzxindustries.net/
- basics: analogue video primer https://www.youtube.com/watch?v=kpeRcRG7xFs
- generating video using eurorack modules https://www.youtube.com/results?search_query=video+synth+technique
- lzx forum https://community.lzxindustries.net/c/forum

- Look Mum No Computer video about cadet series https://www.youtube.com/watch?v=WV39aWt71Lk

dalla Cina, al MEFF2019 e anche il nostro spazio punk 8-)

Midifan 现场直播：佛罗伦萨模块合成器展 MEFF 2019 | 一起播

Pierpaolo Cimino aka RTFM
diy eurorack, built with love
(y) mi raccomando (y)

Two days among cables and k***s.
This is MEFF 2019!

alternative firmware for RadioMusic 8-)
http://www.hora-music.be/firmwares.php

Firmwares

great...

electro-music.com wiki | Schematics / Dual Universal Slope Generator < Serge Negative Slew | Schematics | Triangle thru zero VCO >< Slope Detector for music synthesizers by Ken Stone | Listbytype | Aries AR-312 Envelope Generator >