Baldwin Solid Surfaces

Do your solid surface tops need a repolish - give us a call. We provide a service to bring your worktops back to the same finish as when they were fitted.

🛠 Kitchens • Bathrooms • Restaurants • Commercial counters
✔ Remove scratches & marks
✔ Restore shine & smooth finish
✔ Cost-effective vs replacement

Super bendy solid surface.

Last couple of days on this.
White for dental.
Just need to make top caps and polish!
We don't only do domestic stuff.
Baldwin solid surfaces.

This is what we do!

Made and fitted these Staron worktops 7 years ago. Returned last week for a re-polish and buff up. Looks as good as when they were fitted.
Solid surface material is great for Your kitchen.
Find us in Middlesbrough

https://instagram.com/baldwinsolidsurfaces?igshid=1cp5oxaw24z3h

solid surface bendy counter top. Little bit of thermoforming using our Global vacuum press and oven. We are in Middlesbrough and cover all of the Northeast and beyond if required.

Made and fitted new counter tops for Manjaros in Ormesby.
collina mirage solid surface material. Prepared in the work shop and joined on site.
Perfect for your kitchen - we are in Middlesbrough - contact us for all you solid surface and CNC requirements.

Today, I finished the install of this solid surface piece. This was made for a new Mosque in Acklam, Middlesbrough. Mdf and timber structure clad in Staron Bright white solid surface. Many thanks to in Guisborough for the back panels behind the fretwork- great job! Whole job 3.2m x 3.2m and 500mm off the wall. All made single handedly by me- tough job!

# # 🕌

Cutting the #staron fretwork to replace the mocked up mdf. Had to join the Staron to make a large enough piece and then cnc machined it on our #shopbot cnc machine. 2 more large areas using the same process, paint the back panels and we should be close to fitting. #Mosquedesign #bespokedesign #staronsolidsurfaces #solidsurfacedesign #cncmachining #corian #himacsdesign #himacseurope #himacs #solidsurface #solidsurfaces #onmyown #cnc

Cutting the fretwork to replace the mocked up mdf. Had to join the Staron to make a large enough piece and then cnc machined it on our cnc machine. 2 more large areas using the same process, paint the back panels and we should be close to fitting.