Dynotune Racing

Couple of Evo X's keeping the rollers hot in the last 24 hours!! 🔥🔥

First up completely stock long block GTX3576r powered Evo X with bolt ons owned by .jayden dialed into a nice 512AWHP and 419 FT LBS on pump gas and 32 psi.

Second up, SST stock turbo X with full bolt ons dialed into a nice 370AWHP and 380FT LBS on pump 94 octane after we did an FMIC and piping upgrade.

Lastly we upgraded the turbo on 2014 Evo X to a stock frame 11 blade wheel, new ACT clutch and Flywheel, full fluids maintenance, fresh OEM plugs and fuel pump relay, full 3" exhaust, added Tephra V3 ROM and set the car up with dual maps, low boost and high boost:
268AWHP 286 FT LBS at 22 psi
386AWHP 390 FT LBS at 32 psi

Evo X guys. We can take care of all of your needs 💯🧑‍🔧

Super clean 1993 Dodge Stealth RT TT all buttoned up and ready to go!!
We fixed a bunch of quirks on this car and got it to perfection 👌

Transmission removed and overhauled to fix leaky input bearing and output seals.
Replaced all spark plugs.
Changed all belts and idlers.
New starter
New CV axle
All fresh fluids
Fixed fuel pressure issue
Added missing dowels to engine/trans and transmission case bell housing.
Fixed a pesky o2 sensor issue which was fouling out the plugs.

Runs like a charm now 💯🧑‍🔧

Evo 8 MR on the dyno this afternoon after we fixed a bunch of vacuum leaks, installed a 4 bar map sensor and converted over to tephra V7 full speed density.

Got this idling rock steady, driveability perfectly smooth and dialed into 313 AWHP 334 FT LBS with some very minor bolt ons 💯

2018 Subaru WRX with stock FA20 DIT engine getting dialed in this afternoon via open source tunin/ Subaru Edit.



We installed a full 3" turbo back exhaust, Grimspeed 3 port, and Tomei headers. Car also has Cobb intake, EGR and TGV deletes.

We got everything loaded up and sorted out via Subaru Edit open source software, turned off all necessary DTCs, dialed in on 93 octane, 23 psi of boost:
253 AWHP 324 FT LBS

FA20 owners, give me a call 647 202 6701 or DM to get booked in for your open source tune!! 💯🧑‍🔧

fa20

Fully built super spicy 2017 Subaru STI on the dyno this afternoon getting dialed in!!


Full speed density tune
Stock ECU using Dimemod ROM/ open source
GTX3576r T3 setup
Fully built engine
ID1050x
Pump 94 octane
Snow Performance m**h kit
All fab work done by
100% m**hanol
Other basic supporting mods

603AWHP and 559FT LBS at 31 psi then we started running out of fuel 💯💯

subiegang

Mitsubishi Lancer Evolution VIII 5 speed transmission rebuild completed in house 💯

New 4.09 Final Drive
New input shaft
New OEM 5th input gear
New carbon syncros 1-5 and R
New OEM 1-2 sleeve
New OEM 3-4 sleeve
New OEM 5-R sleeve
New OEM bearings
New OEM seals
New OEM syncro springs
Cases hot tanked, cleaned and painted
All preloads reset

Shoot me a DM or call 647-202-6701 for any transmission repairs or rebuilds 🧑‍🔧

Final Edition Mitsubishi Lancer Evolution X on the dyno with very minimal mods getting a tephra v3 tune this evening!!

This car only has an ETS intake, full 3" exhaust with hi flow cat, stock IC and stock piping, and stock crushed blow off valve.

Dialed into a nice 325AWHP 357 FT LBS, pump 94 octane, open source, Ecuflash and Tephra V3👌

Another AGT 64mm powered Evo X dialed in and ready to go !!

Completely stock long block
We installed the following parts:
AGT 64mm bolt on turbo
ID1300 injectors
DW340lph drop in pump
MAP cast exhaust manifold
ETS intake, full exhaust, and other basic support mods
94 octane pump gas

Effortlessly made a nice 529 AWHP and 399 FT LBS at 32psi peak boost 💯🥳

Beautiful Mitsubishi Lancer Evolution IX on the dyno this evening getting dialed into a nice 520AWHP and 434 FT/LBS, pump gas, m**h injection and completely stock long block with a BW turbo and complete bolt ons.

Flavio just converted the car over to a Haltech Elite 2500 ECU from the 2000 Elite ECU in order to run DBW and eliminate the idle motor. Setup all the DBW components perfectly, a nice Haltech UC10 dash to complement the ECU and a Snow Performance m**h kit. Got this dialed in all perfectly tonight and idling like a dream on the DBW setup!!

Another MK4 Supra Getrag V160 transmission rebuild completed for

This is a Type A V160 with the 7 teeth syncro profile. We changed all 1-4 middle syncros, 3-4 inner syncro liners, 4th outer liners, and 2nd gear with new OEM parts (which are discontinued now).

🙏 for the parts hookup !!

Cases were hot tanked, cleaned and painted to give it that fresh OEM look 🧑‍🔧💯

Need your Supra or Skyline V160 - V161 built? Look no further, I can take care of your needs. Feel free to call 647 202 6701 or DM for pricing 💪