Taurus Robotics

Custom smartwatch cases using SLA 3D printing method ⌚

Just starting out with a new project, this platform will serve as an upgrade over the Fire and Rescue vehicle, since it will have loads of emprovment both in mechanical and electrical/software aspect. For starters it will have around 1kW of power and about 1-2hr operating time, upgraded suspension and chassis which are now both out of stainless steel. The top speed will range from 3km/h to almost 10km/h. On top of that the platform will be almost 1kg lighter, in terms of range, with the ELRS transmission system the range will be increased significantly, potentially up to 10-30km. Also if the platform performs good I will be installing HD FPV system onto it.

Getting there slowly...

All part are now galvanised and ready for painting, then assembly 🔧🪛

Rollcage done ✅

Rollcage held together by hopes and dreams ✨..

Main chassis done with drive sprockets and track pads, next step is galvanising this batch of parts 👨‍🏭🗜

Polished and ready for welding 🔗

Large laser cutting session done. Next step to do will be grinding everything down and preparing the parts for welding 👨‍🏭🗜

💥 New laser cut parts from construction steel material for my new RC vehicle 💥

The design for new platform is coming together nicely, the model is still rough around the edges but will serve as a rough representation of the real thing. Some basic specs ⬇️

*️⃣ 3kw power output of the transmission

*️⃣ ExpressLRS radio control protocol with 5km+ range

*️⃣Analog fpv system range with range 500-1000 meters

*️⃣2 separate power systems with 12v and 5v outputs for verity of tools and add ons.