Riff Raff Guitar Solutions

Haven’t posted in a while, too many generic guitars. But check out this custom built guitar!
Made in NSW, Australia

From us here at Riff Raff Guitar Solutions, we’d like to wish all our friends, followers and clients a Happy New Year.🥳 🎸

Before & After

Upgrades nearly complete. Wiring needs finishing but missing a few bits!!

Here’s a mod you haven’t seen yet!

Yeah I’m upgrading my car! 😂
Works in progress, it’s bloody hard when you’re still suffering pain from a broken spine….
Should be finished tomorrow.

How about this SG I had on the bench for a pick up swap.
Set up was all over the place, negative neck relief & bridge as high as!
Electronics are the plug n play sort so i had to source parts and retro fit the new plug into place. All good now, action, neck relief, bridge height and intonation all set and sounds soooo sweet.

What a great little guitar this Hohner was to work on. Set up & fret dressing.

Just had this gorgeous Gretsch on the bench for a setup.
Come up real nice after a professional polish 👌🏽

I’ve been quiet here lately but I’ve been busy in the shop. Here’s a few guitars I’ve done.
Sire Bass - setup & fix issues with vol/tone pot.
Greco LP - setup & repair to neck damage.
Martin - setup & L.R. Baggs system fitted.

We appreciate your kind words! Thank you,Steve, for taking the time to share your experience with us.
______________________________
Riff Raff Guitar Solutions
📍 31 Eileen St, Walkerston, AU

Bit of a wiring issue on this ESP LTD. Switch was swapped out due to a dead switch position. New switch, dead in a different spot….. ok…. Investigate wiring and re-wire the guitar to Seymour Duncan specs as it’s running SD pups. New problem….. now pos1, pos4 & pos5 dead….. I’ve emailed Seymour Duncan regarding the issue after following their specs.
Really hoping for a good response from SD over this and a solution is near!
If you have any input, I’d be happy to listen.
(Original wiring shown, I’ll update with current SD wiring soon)