Cripple Cut

36inch Olive Wood and epoxy table in process. Considering a cast metal pedestal base. If I find a buyer before completion I’ll let them decided.

Mesquite with epoxy coffee table.

Same mesquite burl but wiped down and in the sun.

Joint project with my wife. Mesquite burl and epoxy plant stand, small side table.

Another cribbage board with a bit of epoxy.

Cribbage Board…I’ll post a few more soon. No CNC, so my friend helping out is still working on keeping the holes straight. Not bad overall though.

🤷‍♂️

Finally got the Purple Heart rolling pins I completed awhile ago baked. Baking Purple Heart brings out a deep rich purple. 12, 14, 16, and 18 inch pins.

I haven’t made many boards lately, but here’s a few. One is Brazilian Ipe and (I believe) bubinga. The others are a set of walnut and padauk, one’s a cutting board the other a cheese slicer/charcuterie board.

Finally got a good side grind bowl gouge, so I can make more items, especially hollowing out items. Here’s a few shot glasses and a double/triple shot glass.

Made a few small bowls (oak and poplar). Still working on the hollowing technique, but they got better once I finally got a good bowl gouge and practice. One with a lid. One with a tiny hole (oops).

Tried a few pen, dried flower, etc, holders. Made from desert willow branches.

The right one broke off the lathe before I could fully finish it and get it polished. I glued the bottom back on and called t good.