BuickPerformanceClub.com

67 Skylark Post Coupe just came in the local yard...been sitting for 23 years...good for trim and minor items...original AC car, SP300 trans

Difference in body screws...Flint built Buicks, VIN has an H, and GMAD (GM Assembly Division) Plants with VIN Z, K, etc....the GMAD had Chevelles, Lemans and Cutlass models....all A-body models on the same assembly line...those plants used machine screw threads/fine threads as shown on the right. Flint built cars used coarse thread. Also, the anchor symbol on the screw head is correct for the concours show cars....the screw on the right was "installed/cross threaded" into a Flint car...that is why the threads are somewhat "rolled"....this was a result from a non-Buick guy working on this 71 Skylark.

Brand new 350 balancer...notice the timing mark is not in-line with the keyway....off by 7 degrees....this is why you set timing with a vacuum gage instead of a timing light.....all new/rebuilt parts MUST be inspected BEFORE installation.

Captain RTV strikes again...along with weatherstrip adhesive sidekick....amazing what people try to do....1962 Buick Special V6 with bad bad bad workmanship....excessive use of sealant where it doesn't belong and believe it or not...hardware store bolts/nuts/washers..everywhere!

This applies to many of my friends!

Let's see how many of my Buick friends have seen these shocks before....I don't think GM can get away with shocks named this since this country seems to have an over-abundance of sensitive people!

1973 Buick 455 with Accel HEI set-up, new ignition set-up, Performer 455 intake...located 20 miles west of Tampa $1000....local pick-up.

Anybody interested in a Buick 455? Will check it out Fri morning.

Anybody need 65 Skylark parts??????? It is going in the local yard on Wed.

This explains it.......if you believe dis...got some gold mines in FL to sell for cheap! :P :P :P

How to stop water entering your Buick....easy fix..just time consuming.

Cowl Leaks

How to install new door panels:

Installing New Door Panels I’d like to pass along this information to anyone who may be interested in re-finishing their own door panels. When I purchased my 1971 GS350 in April 2002, it came with a complete, new in the box, Year One Interior set. I took the seats out and dropped them off at the local upholstery shop along w...