DMF Offroad

Another white Gen 3 Raptor. Outfitted with an bumper and lighting.

Been extremely busy and neglecting social media... did this months back but.

springson all four corners on Gen 3.

We have them in stock. Ready to ship. $3400 a set.

Thanks .3 for stopping by. Those look perfect.

MC Ryno 17x9 -12mm Offset, Machined Finish

A bit of an old pic, but we recently installed UCAs and Tie Rods on Gen 2. The badly worn ball joints needed to go.

Also did the front 6 piston setup. Killer little combo.

Ready to upgrade? DM us to get started.

Few pics of a Gen 3 we did a while back. Bumpers, lights, radio, third brake light, tire mount, and intercooler/intake from Cobb. Super clean.

Ready for the 🏜

Much needed baja trip with

Already down to our last RPG Gen 3 W/camera 3rd brake light. Hit us up before it's gone. These things are straight 🔥. They fit so perfectly against the cab. Uses factory mounting holes.
We have them for the Gen 1,2 and 3 trucks.
We have them fully loaded with S2 lights and NMO mount or without lights for those that already have the S2's.

These 3rd brake lights are awesome. They curve top to bottom and side to side making them fit the cab perfectly. The fit and finish is 🔥🔥. Hit us up at to get yours.

Finally got a pic of an LP4 install we did a while back.

LP4 with backlighting mounted on brackets.

Passing 3rd, headed for home.

This installation was anything but a 6-hour job 🤣

From fitment issues to lack missing parts, this fought us the entire way. Every new stage required a custom solution or special order part. Nothing was as expected. Yet, she's 99% done and sounds rowdy already. will knock out the exhaust tomorrow and tuning. Then, off to the owner.

FTW on finding solutions every single time.