FroMan Garage

Just wrapped up a full 3.5” turbo back on this turbo Silverado! It includes a custom built slash cut dual side exit tip, Vibrant ultra quiet resonator, and v-bands in order to make for an easy install!

We’ve finally got the fabrication on the Accord SiR wrapped up! A/C friendly downpipe, and full 3” exhaust utilizing Vibrant Performance muffler and resonator as always! This car is pretty low, so I had to get creative and try to tuck the exhaust as high as possible. Super happy with the outcome! Video in the comments!

We had a customer that needed his sailboat tiller replicated out of stainless steel. No problem, got him back on the water and ready to sail wherever his heart desires!

Got the EM2’s hot parts all wrapped up and installed! Super happy with the outcome of this one, and can’t wait to see it make some jam! Progress has been slow due to juggling 3-4 other projects as well, but we’re seeing the light at the end of the tunnel!

This project has tested me from the very beginning. But we’re finally nearing the end. This customer wanted a custom turbo manifold, and gave me the creative freedom to do whatever I wanted. I’ve always liked the look of the Evo 8/9 forward facing turbo setups, so I decided to give it a try. Super happy with the outcome so far!

The D17A1 doesn’t have any aftermarket intake manifold options, so we got with NTO Designs in order to design and create an adapter in order to run a D16Y8 Skunk2 Pro series intake on a D17A1 engine. We opted to use o-rings instead of traditional paper gaskets to alleviate the hassle of removing gasket material from the mating surfaces when servicing the intake.

We built the turbo manifold and exhaust setup on this K24 powered Porsche 911SC about a year ago. Now we’ve added some EGT b**gs, as well as an O2 b**g so that the Link ECU can keep this stock engine happy for as long as possible!

Weekend warrior Miata in for a floor drop, and a fresh pair of OMP’s!

This R33 Skyline returned after upgrading to a Pulsar turbo. So we knocked out a new downpipe, and connected it to the existing exhaust. Also made a test pipe to remove the cat when needed!